Blue Neon Flex Double Side 220V 240V 120LED/m 8x16mm IP65 Waterproof Full Kit

Blue Double-Sided Neon Flex | 8×16mm (W × D) | 220–240V AC | 120 LEDs/m

This Blue Double-Side LED Neon Flex lights from two faces at once, so the run reads clearly from two viewing directions — free-standing or suspended signs, lettering seen front and back, and balustrades or partitions lit on both sides. It carries 120 LEDs per metre and runs straight from the supplied UK mains plug.

Saturated blue suits bar and club interiors, branding and architectural feature work — not general room lighting. The 8x16mm body bends horizontally and cuts every 1 metre. It draws 7W per metre, rated for around 30,000 hours, and uses roughly 80% less power than traditional glass neon.

We cut each run to length from a 50-metre roll to match your requirement. Every run carries a 1-year warranty and ships with a UK plug, rectifier cable, and end cap. The plug and switch are not waterproof. Outdoors, house them in a dry, sealed enclosure.

Rated IP65, this neon flex suits indoor use and sheltered outdoor spots where only mild splashes or moisture reach it, such as covered patios and sheltered façades. Do not use it near swimming pools, in saunas or bathrooms, or underwater. For any outdoor run, apply heatshrink tubing and silicone sealant at the end cap and front connection to stop water ingress.

In the package: 1 x Double-Side LED Neon Flex, 1 x UK plug with rectifier cable, 1 x End cap, 1 x Pack of clips (1 clip per metre).

Important Installation Notice: Not suitable for recessed installs in the ground or surfaces exposed to direct water or heavy weather — those need IP67 or IP68-rated neon flex. Hardwiring is not supported and voids the warranty; it must run from the supplied plug. For a hardwired install, choose one of our DC neon flex ranges (12V, 24V or 48V).

Questions? Email our team at sales@ukledlights.co.uk.

Specifications

• Colour: Blue
• Emission: Double-sided (lights from two faces)
• Voltage: 220–240V AC (mains)
• Power: 7W per metre
• LEDs per metre: 120
• LED chip: SMD 2835
• CRI: >80
• Dimensions: (W)8mm x (H)16mm
• Cut points: every 1 metre
• Average LED life: 30,000 hours
• Warranty: 1 year
• IP rating: IP65 (indoor and limited outdoor use)
• Dimming: Yes

Delivery
Available services, costs and delivery estimates are shown at checkout for your address. Made-to-measure products may require additional preparation time.

Returns
Eligible unused standard products can be returned in line with our published policy. Products cut or prepared to your measurements cannot be cancelled or returned once preparation has started unless they are faulty.

Read our shipping policy and returns policy before ordering a custom-cut item.